SABA 9241 specifications

Category : Receiver

Brand : SABA

General

Connections

Technical data

Amplifier

Tuner

Special equipment

Other models of the same series:

Successor:

number of inputs: 4
- Phono MM: 1.5 mV / 47 K-ohms (DIN)
- 2x tape, Aux, Monitor: 270 mV / 470 ohms (DIN)
number of outputs:
- 2x Band (DIN)
- 2x headphones: 100 - 2000 643961b8da111c0a15d770a1109a86d4s (DIN)
- connection for infrared transmitter (headphones)
- 3 pairs of Speakers (DIN)

the duration of the performance (total harmonic distortion)
- 8 643961b8da111c0a15d770a1109a86d4: 2 x 52 W
- 4 643961b8da111c0a15d770a1109a86d4: 2 x 70 W
dynamic performance
- 8 643961b8da111c0a15d770a1109a86d4: 2 x 78 W
- 4 643961b8da111c0a15d770a1109a86d4: 2 x 120 W
power bandwidth: 10 - 80.000 Hz (-3 dB, 1% THD)
THD: 0,03% (1kHz) at rated output
Intermodulation: 0,2% (250/8000 Hz, 4:1) at rated output
damping factor (40 - 12,500 Hz):
- 4 643961b8da111c0a15d770a1109a86d4s: 30
- 8 643961b8da111c0a15d770a1109a86d4s: 60
frequency response:
- 18 - 50,000 Hz (±1.5 dB)
- Phono equalization (RIAA 3180/318/75 µs): ±0.5 dB

signal-to-noise ratio (at rated output):
- Phono magn.: 62 dB
- Aux, Tape: 81 dB
Stereo channel separation: 60 dB
Tone control:
- Bass: ± 15 dB (60 Hz)
- Treble: ± 15 dB (15 kHz)

receiving: FM/MW
frequency:
- FM: 87.5 - 108 MHz
- MW: 520 - 1630 kHz
frequency response: 50 - 16,000 Hz
input sensitivity:
- FM, Mono: Of 0.55 µV at 26 dB signal to noise ratio
- Stereo FM: 8 µV for 46 dB Rauschabstend
- MW: 4 µV
stereo threshold: 5 µV
muting threshold: 3 µV
harmonic distortion: 0.2% (UKM Stereo/ Mono)
signal-to-noise ratio:
- Mono: 64 dB
- Stereo: 62 dB
channel separation: 40 dB
selectivity:
- FM: 80 dB
- MW: 54 dB
frequency selection: 1,0 dB (at 1 mV)
in addition to the wave selection:
mirror frequency attenuation: 92 dB
if rejection: 80 dB
ON-suppression: 55 dB

Source selector and function buttons with LED display
switch on the approximation of the level differences between different sources (e.g., records, and Radio)
2 pairs of Speakers, and in addition, 2 speakers for quadraphonic (Quad ro sonic) can be connected
2 headphones connections
output for connection to an infrared headphone amplifier
Loudness and presence separately selectable
Rumble and noise filter can be activated independently
All the connections in DIN version
Analog Tuner with a digital frequency display
Separate Ratio-in the Middle, and signal strength indicator
FM Muting, switchable
AFC switchable

Other models from the same series: 9240 without frequency display, 9240S without frequency display, but, with the station buttons.
This high-end device with a very good VHF receiver has its lovers. Unfortunately, almost all devices have technical defects after about 40 years. Therefore, capacitors, resistors and other electronic components must be replaced. The quiescent current should also be checked and a recalibration of the receiver is recommended.