Kenwood KA-2200 specifications

Brand : Kenwood

General

connectors

Technical data

special features

Number of inputs: 7 (6 rear, 1 front)
- Source: 150mV/47kOhm
- Phono 1/2 switchable MM: 2.5mV / 33.47; 100 kOhm ; MC: 0.1mV / 100 Ohm
- Tape 1/2
- Tuner
- AUX / D.A.D. Back and front switchable
- Main-In
Number of outputs: 2
- Tape 1/2 ( mV/ kOhm )
- Pre-Out
- Headphones
- Speaker A/B (A with Sigma drive)

Source: 150mV/47kOhm

Phono 1/2 switchable MM: 2.5mV / 33.47; 100 kOhm ; MC: 0.1mV / 100 Ohm

Tape 1/2

Tuner

AUX / D.A.D. Rear and front switchable

Main-In

Tape 1/2 ( mV/ kOhm )

Pre-Out

Headphones

Speaker A/B (A with Sigma drive)

Continuous power (with total harmonic distortion)
- 8 Ohm : 2x 150 W at 0.003%
- 4 Ohm : 2x 160 W
Dynamic power
- 8 Ohm :
- 4 Ohm :
Total harmonic distortion: 0.003% at modulation/8Ohm
Attenuation factor: 1,000 at 100 Hz (Sigma Drive B)
Frequency response: DC - 200 kHz (-3dB)
Signal-to-noise ratio:
- High level: 110 dB
- Phono (MM/MC): 76/92 dB
< /li>
Stereo channel separation:
Tone control: Tone defeat switch
- Bass: ± 10 dB
- Treble: ±10 dB
Loudness: 3/6/9 dB at 30/60/90 Hz (separately adjustable)
High Filter : no
Low Filter (subsonic): 6 dB / octave under 18Hz
Mute: Fader button. Press fadet off, press fadet again
Mono switch
Direct/Line-Straight: no
Speaker Off / A / B / A+B switchable

Fading knob (out and in), Front Aux-In
Class G amplifier. Switches between low and high operating voltage depending on the output power. For this purpose, special double transistors: DAT0612N and DAT0612P, as well as DAT1018N and DAT1018P. There is one each per channel, so a total of eight pieces.