Kenwood Model Eleven III specifications

Category : Receiver

Brand : Kenwood

General

Connections

Technical data

Amplifier

Tuner

Special equipment

Other models of the same series:

Device presentation at good-old-hifi

Number of outputs: 6
- here the Enumerate outputs (with level/impedance)
Tape A 150mV 100643961b8da111c0a15d770a1109a86d4 (RCA) 30mV 80k643961b8da111c0a15d770a1109a86d4 (DIN)
Tape B 150mV 100643961b8da111c0a15d770a1109a86d4 (RCA) 120mV 80k643961b8da111c0a15d770a1109a86d4 (DIN)
Headphones 8 643961b8da111c0a15d770a1109a86d4 to 2k643961b8da111c0a15d770a1109a86d4
Speakers A, B and C 4 to 16 ohms
Pre Out 1V 1k643961b8da111c0a15d770a1109a86d4

Continuous power (with total harmonic distortion)
- 8 643961b8da111c0a15d770a1109a86d4s: 2 x 120 Watts (20...20,000 Hz with 0.1% THD)
- 4 643961b8da111c0a15d770a1109a86d4s: 2 x 135 watts according to DIN
Dynamic power
- 8 643961b8da111c0a15d770a1109a86d4s: 2 x 160 watts
- 4 643961b8da111c0a15d770a1109a86d4s:
Total harmonic distortion: 0.1% at full load, 0.05% at 1 watt/8643961b8da111c0a15d770a1109a86d4
Attenuation factor: 60 (8 ohms)
Frequency response: 10...100,000Hz -1dB
Signal-to-noise ratio: MIC 75dB, Phono 80dB, High level 100dB
Stereo channel separation:
Tone control:
- Bass: +/- 10dB at 100Hz
- Midrange: +/- 10dB at 800Hz
- Treble: +/- 10dB at 10kHz
Loudness: (at-30dB) +10dB at 100Hz and +5dB at 10kHz
High Filter : -9dB at 10kHz
Low Filter : -9dB at 100Hz
Mute: not available
Direct/Line-Straight: not available

8 643961b8da111c0a15d770a1109a86d4s: 2 x 120 Watts (20...20,000 Hz with 0.1% THD)
4 643961b8da111c0a15d770a1109a86d4s: 2 x 135 watts according to DIN

built-in Dolby noise reduction, prepared for FM Dolby (but was never introduced)
timer circuit with mechanical clock up to 120 minutes (sleep function)
built-in 400 Hz test tone generator (to level the noise reduction)
four built-in instruments (2 times power, FM center display and field strength)< /li>
dimmable scale lighting
two headphone jacks
wooden housing as standard