Rotel RA-1212 specifications

Brand : Rotel

General

Technical data

Power Amplifier Section

Preamplifier Section

Special Equipment

Other models of the same series:

Amplifier:

Tuner:

Tape Deck:

< p> Turntable:

Rated power 20Hz - 20kHz according to IHF-a with & lt;0.3% THD:
- 8 Ohm : 70W
- 4 ohm: 120W
Sine power 1kHz according to DIN with <=1% THD:
- 8 ohm: 100W
- 4 ohm: 160W
Intermodulations: & lt;0,05%
- 60Hz : 7kHz = 4 : 1 at rated power at 8 ohm
Attenuation factor: 70 +/-10%
Frequency response: 4Hz - 100kHz +/- 1dB at 1 watt at 8 ohm
Input sensitivity and impedance: 980mV at 33 kOhm
Headphones: 4 - 600 Ohm , 0.5W
Speaker impedance: 4 - 16 ohm
- 2 pairs, switchable separately

Output voltage and impedance: 980mV at 100 Ohm , max. 2V
total harmonic distortion (THD): 0.08% in nominal voltage
bandwidth: 3Hz - 50kHz +/-1dB
Signal-to-noise ratio (SNR) in accordance with IHF-a:
- Phono 1+2: <-75dB
- Tape/Tuner/Aux 1+2: <-95dB
noise voltage at the preamplifier output nominal voltage: 1mV
input sensitivity and impedance:
- Phono 1+2: the separately switchable, 2, 4 and 8 mV, 30, 50, and 100 kOhm
  - RIAA-Standard +/- 0.5 dB
- Tape/Tuner/Aux 1+2: 150mV at 50 kOhm
output voltage Tape:
- RCA: 270mV at 2.7 kOhm
- DIN: 60mV at 80 K ohms
Clipping Phono: 200mV at 0.3% THD
Crosstalk: >50dB in all channels
control the sound: on / off switchable
- Bass: +/- 10dB at 400Hz and +/- 7dB at 200Hz
- height: +/- 10 dB at 2 kHz and +/- 7dB at 4kHz
Loudness: switchable
- +7 dB at 50 Hz and +3dB at 10kHz
High Filter : 12dB/octave at 7kHz, switchable
Low Filter : 12dB/octave at 70Hz, switchable
Subsonic Filter : 15Hz cut off, switchable
Muting: -15dB switchable