Restek Tornado specifications

Category : Active speakers

Brand : Restek

General

Connections

Tech nical specifications of amplifiers

Tech nical specifications of loudspeakers

Special equipment

Other models of the same series:

  • Manufacturer: Restek
  • Model: Tornado
  • Years of construction: about 1980
  • Manufactured in: Norhessen
  • Color: Brown
  • Type: Analog
  • Remote control: No
  • Power consumption:
  • Dimensions: 400 x 24 x 515 mm
  • Weight:
  • Factory price approx.:
  • Number of inputs:
    • enumerate the inputs here (with sensitivity/impedance)
  • Number of outputs:
    • Enumerate the outputs here (with level/impedance)
  • enumerate the inputs here (with sensitivity/impedance)
  • Enumerate the inputs here (with sensitivity/impedance)
  • >list the outputs here (with level/impedance)
  • Type: Power amplifier
  • Continuous power (with total harmonic distortion)
    • 8 Ohm :
    • 4 Ohm : 70W
  • Dynamic power
    • 8 Ohm :
    • 4 Ohm :110 W
  • Total harmonic distortion:
  • Attenuation factor:
  • Frequency response: 20 - 20,000 Hz
  • Signal-to-noise ratio:
  • Stereo channel separation:
  • Tone control:
    • Bass:
    • Treble:
  • Loudness:
  • High Filter :
  • Low Filter (Subsonic):
  • Mute:
  • Direct/Line-Straight:
  • 8 Ohm :
  • 4 Ohm : 70W
    • 8 Ohm :
    • 4 Ohm :110W
    • Bass:
    • Treble:
    • Type of construction:
    • Chassis:
      • Cone woofer 170 mm, cone midrange driver 90 mm, tweeter dome 25 mm
    • Load capacity (nominal/music b.): 70 / 110 W
    • Efficiency:
    • Frequency response: 20 - 20,000 Hz
    • Transition ranges: (for LS with multiple chassis) 900, 4,000 Hz
    • Impedance:
    • Cone woofer 170 mm, cone midrange driver 90 mm, tweeter dome 25 mm
    • active correction of the diaphragm deflection of the woofer with the help of a ceramic accelerometer
    • Alignment of the chassis vertically upwards
    • cone via tweeter to scatter the sound
    • Corresponds to the laser model. Electronics, chassis and arrangement of the chassis on the baffle are identical. In principle, the lasers were placed on the back and the case was extended so that the box reached the height of a stool. For the emission of the tweeter, a cone made of plastic was attached above the dome (negatively curved, hyperbolic?).


    Comment:



    Comment box:


    Restek Tornado relate