Mitsubishi DA-R 440 specifications

Category : Receiver

General

connectors

Technical data

amplifier

Tuner

special features

number of inputs:
- Phono: 3,0 mV / 47 K-ohms
- Aux: 200 mV / 47 K-ohms
- Tape 1: 200 mV / 47 K-ohms
- Tape 2: 200 mV / 47 K-ohms
- antenna FM (75/300 643961b8da111c0a15d770a1109a86d4), AT
number of outputs:
- Tape 1: 250 mV
- Tape 2: 250 mV
- headphone (6.3 mm Jack, front)
- 2 pairs of Speakers

continuous power
- 8 643961b8da111c0a15d770a1109a86d4: 2x 20 W
- 4 643961b8da111c0a15d770a1109a86d4: 2x 33 W
dynamic performance
- 8 643961b8da111c0a15d770a1109a86d4s:
- 4 643961b8da111c0a15d770a1109a86d4:
total harmonic distortion: 0.05%
damping factor:
frequency response:
- Phono: only for MM systems
- Aux:
signal-to-noise ratio:
- Phono:
- Aux:
stereo channel separation:
sound-control:
- Bass: 100 Hz, ±10 dB
- treble: 10 kHz, ±10 dB
Loudness: Yes, 100 Hz (plus 7 dB), 10 kHz (plus 5 dB)
High Filter : no
Low Filter (Subsonic): no
Mute: FM Muting
Direct/Line-Straight: no

receiving: FM, MW
frequencies:
- FM:
- MW:
frequency response:
- FM:
input sensitivity:
- FM: 16 µV (75 643961b8da111c0a15d770a1109a86d4)in Stereo
- MW: 600 µV
total harmonic distortion:
- FM: 0,3% (Stereo),
signal-to-noise ratio:
- FM: 69 dB (Stereo), 75 dB (IHF-A)
channel separation:
- FM: 50 dB
selectivity:
- FM: 55 dB
- MW: 30 dB
frequency selection:
- FM:
in addition to the wave selection:
mirror frequency attenuation:
- FM:
ZF-loss:
- FM:
ON-suppression:
RDS: no
station memory: Yes, 7 mechanical and backlit buttons

signal strength of the set channel is displayed on the left of the pointer instrument input Tape 2 has both RCA Jacks as well as a DIN input (diode connector), two cold device socket outlets

Mitsubishi DA-R 440